Lab 1 - Deploy Application

Learn how to deploy an application to a Kubernetes cluster hosted within the IBM Container Service.

0. Prerequisites

Make sure you satisfy the prerequisites as outlined in Lab 0

1. Deploy the guestbook application

Make sure you are logged in to IBM Cloud and you connected to your remote cluster as in the SETUP instructions.

kubectl config current-context

In this part of the lab we will deploy an application called guestbook that has already been built and uploaded to DockerHub under the name ibmcom/guestbook:v1.

1. Start by running guestbook:

   kubectl create deployment guestbook --image=ibmcom/guestbook:v1

   This action will take a bit of time. To check the status of the running application, you can use $ kubectl get pods.

   You should see output similar to the following:

   kubectl get pods

   Eventually, the status should show up as Running.

   $ kubectl get pods
   NAME                          READY     STATUS              RESTARTS   AGE
   guestbook-59bd679fdc-bxdg7    1/1       Running             0          1m

   The end result of the run command is not just the pod containing our application containers, but a Deployment resource that manages the lifecycle of those pods.

2. Once the status reads Running, we need to expose that deployment as a service so we can access it through the IP of the worker nodes. The guestbook application listens on port 3000. Run:

   kubectl expose deployment guestbook --type="NodePort" --port=3000

3. To find the port used on that worker node, examine your new service:

   $ kubectl get service guestbook
   NAME        TYPE       CLUSTER-IP     EXTERNAL-IP   PORT(S)          AGE
   guestbook   NodePort   10.10.10.253   <none>        3000:31208/TCP   1m

   We can see that our <nodeport> is 31208. We can see in the output the port mapping from 3000 inside the pod exposed to the cluster on port 31208. This port in the 31000 range is automatically chosen, and could be different for you.

   Set the NODEPORT environment variable:

   export NODEPORT=<your nodeport value>

4. guestbook is now running on your cluster, and exposed to the internet. We need to find out where it is accessible. The worker nodes running in the container service get external IP addresses. Get the workers for your cluster and note one (any one) of the public IPs listed on the <public-IP> line. Replace $CLUSTER_NAME with your cluster name unless you have this environment variable set.

   $ ibmcloud ks workers --cluster $CLUSTER_NAME
   OK
   ID    Public IP    Private IP    Machine Type    State    Status    Zone    Version  
   kube-hou02-pa1e3ee39f549640aebea69a444f51fe55-w1   173.193.99.136    10.76.194.30    free    normal    Ready    hou02    1.5.6_1500*

   We can see that our <public-IP> is 173.193.99.136.

   Set the PUBLIC environment variable to your worker node Public IP,

   PUBLICIP=<your worker node's public IP>

5. Now that you have both the address and the port, you can now access the application in the web browser at <public-IP>:<nodeport>. In the example case this is 173.193.99.136:31208.

   Get full URL,

    echo http://$PUBLICIP:$NODEPORT

   Or using curl,

    curl http://$PUBLICIP:$NODEPORT

Congratulations, you've now deployed an application to Kubernetes!

When you're all done, continue to the next lab of this course.